High Spec Clutch Slave Cylinder Kit - 40mm Fulcrum Point
We have a new high specification clutch slave cylinder, it is very compact and lightweight. It has been designed to use the highest quality materials and seals to give extended life. The port sizes are M10 x 1mm.
It comes complete with a release bearing fitted and has a 40mm fulcrum point, suitable for:
5.5” (140mm) AP and TTV clutches
7.25” (184mm) & 5.5” (140mm) PTT clutches
We have produce a kit using the new slave cylinder design that allows it to be a direct replacement for the Titan version of slave cylinder and allows you to bolt it directly in place of the original unit.*
*When replacing the Titan version, please check the installed height is the same as the unit you are removing and if not, you may need to make changes to your installation to ensure correct operation of the clutch.
The 46mm fulcrum point version CLT-HCA-46-TTV-KIT-01 is suitable for use on 7.25” (184mm) AP & TTV clutches as well as most other clutches of this type, please check your fulcrum point from your clutch supplier.